The AM26LV32E device consists of four differential line receivers and has three-state output. The device is designed to meet the requirements of TIA/EIA-422-B and ITU Recommendation V.11 drivers with a small power supply voltage. This device is optimized to achieve balanced bus transmission at switching rates up to 32MHz. Through tri-state output, the device can be directly connected to the bus organized system. The AM26LV32E has a fail-safe circuit, which can prevent the device from placing an unknown voltage signal at the receiver output. In the open-circuit failure protection, a high-level state will be generated at the corresponding output terminal. The device supports local power-off applications using I off. I off circuit can disable the output to prevent the device from being damaged by current backflow when the device is powered off.

Meet or exceed the requirements of TIA/EIA-422-B and ITU Recommendation V.11 standards.
It is operated by a single 3.3V power supply.
The switching frequency is as high as 32MHz.
ESD protection of RS422 bus pin (refer to ESD level)
Low power loss: 27mW (typical)
Open circuit failure protection
7V common-mode input voltage range with ±200mV sensitivity
Accept 5V logic input and 3.3V power supply (enable input).
Input hysteresis: 35 mV (typical)
Compatible with AM26C32 and AM26LS32 pins.
I off supports local power-off mode operation.